Chapter 7 — Setup Mode
E T U P :
P R I N T D E F
E T U P :
M E D I A
70
EasyCoder PF2i Bar Code Label Printer User's Guide (Fingerprint Version)
The Setup Mode is organized as an endless loop, from which you
can select a number of sub-categories. At startup, the firmware
determines if options such as a label taken sensor, a cutter, or an
interface board is installed in the printer. Only installed options
are shown in the Setup Mode.
The diagram below shows the options in the main loop. Detailed
overviews are shown on the pages that follow.
Starting point
E T U P :
E R - C O M , U A R T 1
E T U P :
F E E D A D J
E T U P :
E R - C O M , U A R T 2
Option
E T U P :
E R - C O M , U A R T 3
E T U P :
N E T - C O M , N E T 1
Option
E T U P :
N E T W O R K
Option
Option