Intermec EasyCoder PF2i User Manual page 110

EasyCoder PF2i Bar Code Label Printer User's Guide (Fingerprint Version)
Display Messages and LED Indications (continued)
Error/Event
LSS too low
Testfeed not done
Pause Mode entered
Setup Mode entered
IP link error
IP configuration error Blink
Generic DP error
Press any key to
continue
Application load error Blink
IRI blink by
application
IRI off by application Off
Application break
Printhead not found
Rebooted
Initializing
Printer crash
Printer turned off
Maintenance
Power supply Over
temperature
Note 1: This is only applicable for printers equipped with an EasyLAN
interface.
Note 2: A printer that is equipped with an EasyLAN interface, but is not
connected to a network, will have a blinking IRI. To avoid this, the user
can set "IP SELECTION" to "MANUAL" and "IP ADDRESS" to
"0.0.0.0". This will indicate that the user does not regard the lack of
network connection as an error.
Note 3: No trap can be sent when this error/event occurs.
Chapter 10 — Troubleshooting
IRI Error No. Comment
Blink 1008
Blink 1606
Blink
Blink Including interactive
setup from Fingerprint/
Direct Protocol
Blink See note 1, 2, and 3
See note 1, 3, and 4
Blink See note 5
Blink See note 6
See note 7
Blink Set by Fingerprint
instruction SYSHEALTH
Set by Fingerprint
instruction SYSHEALTH
Off See note 8
Off
Off
Off Set at startup until
operational
Off See note 3 and 9
Off
Off Set when upgrading
Off 1718
95