Peel-Off (Self-Strip) - Intermec EasyCoder PF2i User Manual

Peel-Off (Self-Strip)

EasyCoder PF2i Bar Code Label Printer User's Guide (Fingerprint Version)
The EasyCoder PF2i printer can print on labels, tickets, tags, and
continuous stock in various forms. This section describes the case
when self-adhesive labels are separated from the liner
immediately after printing. The liner is then wound up on an
integral liner takeup hub. This is also known as "Self-strip"
operation.
Peel-off operation cannot be performed when quick-load guides
are fitted.
Use the Feed key when loading the same type of media. When
switching to a new type of media, or if the printer does not feed
out the media properly, simultaneously press the Shift and Feed
keys to perform a "Testfeed."
Peel-off can only be used for:
• Self-adhesive labels with liner
An optional label-taken sensor can hold the printing of the next
label in a batch until the present label has been removed, see
"Label Taken Sensor" on page
Note: Peel-off operation sets high demands on the media in
regard of label stiffness, release characteristics of the adhesive and
liner, resistance against electrostatic charging etc., so the labels
will be dispensed properly. Consult your media supplier or test
the media to ascertain that it is suitable for your application.
Chapter 4 — Media Load
91.
33