Connections; Power; Computer - Intermec EasyCoder F2 Installation And Operation Manual

Connections

Power

Computer

Intermec EasyCoder F2 – Installation & Operation Ed. 1
1 Place the printer on a level surface, near a mains electrical outlet
and with easy access for loading paper and ribbon, and for
removing printout.
2 Check that the printer is switched off.
3 Connect the power cable to the mains receptacle on the rear plate
and to the electrical outlet.
The Easycoder F2 is fitted with one DB25 female connector for the
RS 232 serial interface port and one class B connector for the USB
port (see Appendix 3).
• RS 232 Serial Interface
Use the serial interface with Direct Protocol or Intermec Fingerprint
programming because you can receive error messages from your
printer. Before you can use the serial interface, you may need to
set up the communication parameters, such as baudrate, parity
etc. as described in chapter 6 "Setting Up the Printer".
• USB Interface
The USB interface is intended for future applications.
• Optional Interface Board
Refer to Appendix 3 and the separate documentation delivered
with the boards for connection and setup instructions.
Switch off both the PC and the printer before connecting them to-
gether.
Chapter 3 Installation
23