Connections; Power; Computer; Serial Interface ("Uart1:") - Intermec EasyCoder PM4i User Manual

Connections

Power

Computer

EasyCoder PM4i Printer User's Guide (Fingerprint Version)
To connect the power
1 Place the printer on a level surface, near an AC outlet. You
should be able to easily access the printer to load media and to
remove the printout.
2 Check that the printer is switched off.
3 Connect the power cord from the socket on the rear plate to
an electrical outlet (90 to 265 VAC).
The Easycoder PM4i is fitted with one 9-pin D-style
subminiature (DB9) socket for the RS-232 serial interface port
and one class B connector for the USB interface port
see "Interfaces" on page
RS-232 Serial Interface ("uart1:")
Use the serial interface with Intermec LabelShop or the Intermec
InterDriver. Also use it with the Intermec Direct Protocol or the
Intermec Fingerprint programming language because you can
receive error messagesn from your printer. Before you can use the
serial interface, you may need to set up the communication
parameters, such as baud rate, parity, etc. as described in
Up the Printer" on page

USB Interface ("usb1:")

Use the USB interface with an USB-compatible version of the
Intermec InterDriver for printing. The USB interface is not
suitable for programming because the host cannot receive error
messages from your printer.
Optional Interface and Network Boards("uart2:", "uart3:",
"uart4:", "uart5:", "centronics:", and "net1:")
Several types are available (see
Chapter 6, Chapter 7, and Appendix C for connection and setup
instructions.
Chapter 2 — Installation
139.).
51.
"Options" on page
(For help,
"Setting
83). Refer to
11