Protocol Settings For The Printer; Protocol Settings Using The Remote Ui - Canon LBP-3300 Network Manual

Protocol Settings for the Printer

After installing the printer driver, perform the protocol settings for the printer as
needed. You can perform the protocol settings from the computer you are using,
using any one of the following software.
2
I Protocol Settings Using the Remote UI (See p. 2-60)
Perform the protocol settings by accessing the printer from your web browser via the
network.
I Protocol Settings Using NetSpot Device Installer (See p. 2-70)
Perform the basic protocol settings by starting NetSpot Device Installer from the supplied
CD-ROM or the one installed. When configuring the DNS server etc., use the Remote UI
or FTP Client.
I Protocol Settings Using FTP Client (See p. 2-74)
Perform the protocol settings by accessing the FTP server in the network board using
Command Prompt (MS-DOS Prompt for Windows 98/Me).

Protocol Settings Using the Remote UI

1
2-60 Protocol Settings for the Printer
Run the web browser, enter the following URL in [Location] or
[Address], and then press the [ENTER] key on your keyboard.
http://<the IP address or name of the printer>/
Input Example : http://192.168.0.215/
IMPORTANT
•
If you are not sure about the IP address of this printer, refer to the Network Status
Print printed in "Checking the Operations with Network Status Print" (p. 2-57) or
ask an administrator of the printer.
•
Use Netscape Navigator/Communicator 4.7 or later or Internet Explorer 4.01SP1
or later as the web browser.
•
You cannot connect the computer to the printer via a proxy server. If you are using
a proxy server, perform the following settings. (The setting varies depending on the
network environment.)
- On the settings for the proxy server of the web browser, add the IP address of this
printer to [Exceptions] (The addresses that do not use the proxy server).
•
Configure the web browser so that you can use Cookie.