Canon LBP-3300 Network Manual page 41

IP Address:
MAC Address:
Input Example:
NOTE
The MAC address is indicated on the reverse side of the network board (A) as
shown in the following figure.
3
Enter the following command, then press the [ENTER] key on
your keyboard.
ping <the IP Address> -l 479
IP Address:
Input Example:
The IP address is set on the network board.
NOTE
•
l of "-l" is the letter "L" of the alphabet.
•
The subnet mask and gateway address are set to [0.0.0.0].
4
Enter "exit", then press the [ENTER] key on your keyboard.
Exit Command Prompt or MS-DOS Prompt.
Next, install the Canon CAPT Print Monitor. (See p. 2-26)
Specify the IP address to assign to the printer. Specify the address
with four numbers (from 0 to 255) separated with a period (.).
Specify the MAC address of the printer. When entering the number,
separate the number every two digits with a hyphen (-).
arp -s 192.168.0.215 00-00-85-05-70-31
(A)
Specify the same IP address as the one used in Step 2.
ping 192.168.0.215 -l 479
Installing the CAPT Software
2
2-23