Managing The Printer Using The Remote Ui - Canon LBP-3300 Network Manual

Managing the Printer Using the Remote UI

This section describes the procedures for performing the following management
options using the Remote UI.
•
Restricting the Users Who Can Print (See p. 3-4)
•
Restricting the Users Who Can Monitor/Change the Settings Using the SNMP
Protocol (See p. 3-10)
•
Restricting the Users Who Can Perform the Multicast Discovery (See p. 3-18)
•
Restricting the Devices That Can Access with MAC Addresses (See p. 3-23)
•
Obtaining/Checking the Security Access Logs (See p. 3-29)
•
Initializing the Network Settings (See p. 3-37)
You can also perform these management options using FTP Client.
IMPORTANT
•
If you are not sure about the IP address of this printer, refer to the Network Status Print
(See "Checking the Operations with Network Status Print," on p. 2-57) or ask the
administrator of the printer.
•
Use Netscape Navigator/Communicator 4.7 or later or Internet Explorer 4.01SP1 or later
as the web browser.
•
You cannot connect the computer to the printer via a proxy server. If you are using a
proxy server, perform the following settings. (The setting varies depending on the
network environment.)
- On the settings for the proxy server of the web browser, add the IP address of this
printer to [Exceptions] (The addresses that do not use the proxy server).
•
Configure the web browser so that you can use Cookie.
•
If multiple Remote UIs are running simultaneously, the latest setting is effective. It is
recommended that only one Remote UI should be running at a time.
NOTE
Depending on the system environment, the screen for the Remote UI is not displayed. In
this case, enter "http://<the IP address of this printer>/cab/top.shtml" in [Address] or
[Location] to redisplay the screen.

Managing the Printer Using the Remote UI

3
3-3