Canon LBP-3300 Network Manual page 25

NOTE
Depending on the system environment, "192.168.0.215" (the default value for the
network board) is displayed in [IP Address] under [Printer List]. If you want to
change the IP address, see "Protocol Settings for the Printer" (p. 2-60) to change
the IP address after finishing the installation.
G When [Unknown Device] is displayed in [Device Name]
❑
Select the printer displayed as [Unknown Device], then click [Set IP Address].
NOTE
If more than one [Unknown Device] are displayed, select the MAC address of the
printer to be installed. The MAC address is indicated on the reverse side of the
network board (A) as shown in the following figure.
❑
Enter the IP address of the printer in the [Set IP Address] dialog box, then click
[OK].
(A)
Installing the CAPT Software
2
2-7