Installing The Printer Driver; Performing The Protocol Settings For The Printer - Canon LBP-3300 Network Manual

I Performing the Protocol Settings for the Printer
* Specify the protocol settings as needed.
There are three kinds of methods to perform the protocol settings, and the specifiable options vary depending on
the application.
Protocol Settings
Using the Remote
UI (See p. 2-60)

Installing the Printer Driver

The printer driver is software required for printing from an application you use.
There are the following two ways to install the printer driver. The procedures for
setting the IP address or creating a port (Canon CAPT Port) required to print in a
network environment vary depending on the installation method.
I Installing the CAPT Software from CD-ROM Setup (See p. 2-2)
If you install the printer driver from the supplied CD-ROM (CD-ROM Setup), you can
easily configure the printer to print in a network environment by setting the IP address and
creating a port at once.
I Installing the Printer Driver Manually Using Various Utility Software (See p.
2-14)
Specify the IP address or create a port using the software in the supplied CD-ROM
("NetSpot Device Installer" or "Print Monitor Installer"), the ARP/PING command or
others, and then install the printer driver from [Add Printer Wizard].

Performing the Protocol Settings for the Printer

After installing the printer driver, perform the protocol settings for the printer as
needed. You can perform the protocol settings from the computer you are using,
using any one of the following software.
I Protocol Settings Using the Remote UI (See p. 2-60)
Perform the protocol settings by accessing the printer from your web browser via the
network.
I Protocol Settings Using NetSpot Device Installer (See p. 2-70)
Perform the basic protocol settings by starting NetSpot Device Installer from the supplied
CD-ROM. When configuring the DNS server etc., use the Remote UI or FTP Client.
I Protocol Settings Using FTP Client (See p. 2-74)
Perform the protocol settings by accessing the FTP server in the network board using
Command Prompt (MS-DOS Prompt for Windows 98/Me).
Requisite Tasks Before Printing or Managing the Printing Operation
Protocol Settings
Protocol Settings
Using NetSpot
Device Installer
(See p. 2-70)
Protocol Settings
Using FTP Client
(See p. 2-74)
1-3
1