Canon LBP-3300 Network Manual page 183

5
Open the config file downloaded by Notepad, etc.
6
Edit "PS_NAME" to the port name of the computer (the port
name specified in Step 11 (See p. 5-16) of "Installing the
Printer Driver")
Input Example : PS_NAME. :192_168_0_215
IMPORTANT
Be sure to match "PS_NAME" in the config file with the port name of the computer.
7
Edit "YES" to "USE_IP_PORT_NAME".
Input Example : USE_IP_PORT_NAME. :YES
8
Save the config file.
9
Enter the following command, then press the [ENTER] key on
your keyboard.
put <File Name> CONFIG
NOTE
In <File Name>, enter the name of the config file that was entered when the file
was downloaded.
10
Enter the following command, then press the [ENTER] key on
your keyboard to reset the network board.
get reset
After completing the reset of the network board, the settings are effective.
NOTE
The settings also become effective by restarting the printer (Turn OFF the printer
once, wait for 10 seconds or longer, and then turn it ON).
11
Enter "quit", then press the [ENTER] key on your keyboard.
12
Enter "exit", then press the [ENTER] key on your keyboard.
Command Prompt or MS-DOS Prompt exits.
Using the Unicast Communication Mode
5
5-19