Download  Print this page

Ip Address Setting Using Netspot Device Installer - Canon LBP-3300 Network Manual

Laser beam printer.
Hide thumbs

Advertisement

NOTE
The MAC address is required to set the IP address using the ARP/PING command. The
MAC address is indicated on the reverse side of the network board (A) as shown in the
following figure.

IP Address Setting Using NetSpot Device Installer

IMPORTANT
If you are using Windows XP Service Pack 2 or another operating system equipped with
Windows Firewall, and the Windows Firewall is enabled, it is recommended that you set
the IP address using the ARP/PING command. For details on the procedure for setting
the IP address using the ARP/PING command, see "IP Address Setting Using the ARP/
PING Command," on p. 2-22.
If you are using Windows XP Service Pack 2 or another operating system equipped with
Windows Firewall and the Windows Firewall is enabled, and when you set the IP address
using NetSpot Device Installer, perform either of the following procedures.
- Add "NetSpot Device Installer" to the [Exceptions] sheet in the [Windows Firewall]
dialog box (See Readme of NetSpot Device Installer)
- Installing NetSpot Device Installer (See p. 3-46)
NOTE
The screen shots used in this section are from Windows XP Professional.
This section describes the procedure for using NetSpot Device Installer without installing
it. For details on the procedures for installing NetSpot Device Installer, see "Managing the
Printer Using NetSpot Device Installer," on p. 3-45.
(A)
Installing the CAPT Software
2
2-15

Advertisement

Table of Contents

   Related Manuals for Canon LBP-3300

This manual is also suitable for:

Laser shot lbp5000

Comments to this Manuals

Symbols: 0
Latest comments:
  • ram Dec 14, 2014 12:43:
    how to sharing canon printer LBP 3300