Installing The Canon Capt Print Monitor - Canon LBP-3300 Network Manual

2
6
Next, install Canon CAPT Print Monitor. (See p. 2-26)

Installing the Canon CAPT Print Monitor

NOTE
The screen shots used in this section are from Windows XP Professional.
1
2-26 Installing the CAPT Software
[IP Address]:
Options to be specified as needed
[Subnet Mask]:
[Gateway Address]:
[Password]:
NOTE
•
If [RARP] is selected, you cannot enter any value in [IP Address].
•
If [BOOTP] or [DHCP] is selected, you cannot enter any value in [IP Address],
[Subnet Mask], and [Gateway Address].
•
If you cannot use RARP, BOOTP, and DHCP, specify [Manual Setting].
After completing the settings, click [OK].
The Printer Status Window reappears.
Insert the supplied CD-ROM into the CD-ROM drive.
If CD-ROM Setup appears, click [Exit].
[BOOTP]: Obtains an IP address using BOOTP.
(The BOOTP daemon needs to be
started up.)
[DHCP]: Obtains an IP address using DHCP.
(The DHCP server needs to be started
up.)
Enter the IP address of the network board.
Enter the subnet mask that is being used on the
TCP/IP network.
Enter the gateway address that is being used on
the TCP/IP network.
Enter the administrator password for the network
board. If the password has not been specified yet, it
is not required to enter the password.