Initializing the Network Settings
Secure the top and bottom portions of the network board with
the two screws supplied with the network board.
Connect the power cord.
Plug the power plug into the AC power outlet.
Press " " of the power switch to turn the printer ON, wait until
the Ready indicator comes on, and then press "
power switch to turn the printer OFF.
Disconnect the power plug from the AC power outlet.
Remove the power cord.
Remove the network board, then reset the DIP switch 1 (A) to
Set the DIP switches with the tip of a ball-point pen etc.
E R R
N B -
When setting the DIP switches, be careful not to damage the main board with the
tip of a ball-point pen etc. Do not use a sharp object such as a mechanical pencil.
1 0 0
L N K
" of the