Jasic EVOLVE 200 Operator's Manual page 103

OPERATION - DIGITAL MIG TORCH
Digital MIG Torch Operation Option
The Evolve 200 can be operated with the premium range of Starparts Hard Core MIG torches which
offers the operator the ability to operate certain MIG functions from the MIG torch
handle, this optional 4 button torch handle control module (shown right).
The 4 button control module Pt No HC4BCM clips into place on the HC300, the Hard
Core 300A Air Cooled Mig Torch which is available in 3m, 4m or 5m lengths.
The Hard Core MIG torch range is pre-wired to accept the 4 button control module
and once clipped into place will allow the operator to control a number of MIG
functions on the Jasic Evolve plus machine.
Image 1
In Standard MIG mode:

Using buttons A or B will increase or decrease your wire feed speed.

Using buttons C or D will increase or decrease your welding voltage.
In Synergic/Pulse MIG mode:

Using buttons A or B will increase or decrease you're welding amps, if wire feed speed or material
thickness is displayed in the top display, you will also see these values increase or decrease.
Welding voltage will also increase and decrease as well.

Using buttons C and D will increase or decrease your welding voltage only.
Image 2
A - Increases wire feed speed.
B - Decreases wire feed speed.
C - Increases welding voltage.
D - Decreases welding voltage.
A - Increases welding amperage.
B - Decreases welding amperage.
C - Increases welding voltage.
D - Decreases welding voltage.
Fitting the 4 button control module is simple, first
remove the black plastic cover by pressing in either
side of the cover (as shown with the red arrows in
image 1 left) and then pulling the cover away.
Now offer the 4 pin control module to the torch
handle and push fit in into place, you will note that it
does clip into place as shown left in image 2.
Please Note:
The optional 4 button control module is only designed
to be used with the Jasic Evolve and the EVO range of
machines.
103