Jasic EVOLVE 200 Operator's Manual page 106

APP REMOTE CONTROL
Before starting any welding activity please ensure that you have suitable eye protection and
protective clothing. Always take the necessary steps to protect any persons within the welding
area.
App remote control (Continued)
The JTE cloud app will not change between welding modes i.e. from MMA mode to TIG mode, this
operation can only be carried out via the Evolve user screen.
If you change the welding mode on the machine
from MMA to TIG mode, the JTE app screen will
sync and instantly change to show TIG mode as
shown in image (G) right and the TIG setup details
will be shown.
From here you can select and change various TIG
welding parameters, for example if you press the
DC Pulse tab a drop down menu will open up
where you can select the various pulse options,
including DC, DC Pulse or DC Pulse MIX, pressing
an alternative will save your selection and return
you to the main screen.
If you swipe the app screen left, you will then enter
further TIG welding parameters as shown in image
(H) right. From here, pressing each available TIG
parameter will allow you to adjust the chosen TIG
parameter.
Image (I) below, shows that the machine welding
mode is now in manual MIG mode which the app screen has replicated. If you press the 'Manual' icon you
will see a drop down menu where you can select the various MIG mode options, if you press 'twin-pulse'
as image (J) shows, the machine is now in Double (twin) Pulse MIG mode. Swiping the screen left will
open up the secondary screen (K) as shown below that offer various other parameters available for
double pulse. Scrolling down will show further parameters that are off screen and out of view.
I J
106
G H
K