Advertisement
Advertisement
Related Manuals for Jasic MIG 270 Separate
Summary of Contents for Jasic MIG 270 Separate
- Page 1 A WILKINSON STAR PRODUCT 10-17 ISSUE 3...
-
Page 2: Table Of Contents
Contents Section Title Page Your new product Safety Product overview Panel layouts Unpacking Input and output connections Maintenance and troubleshooting Technical Parameters A WILKINSON STAR PRODUCT 10-17 ISSUE 3... -
Page 3: Your New Product
Your new product Thank you for selecting this Jasic Technology, Wilkinson Star product. This product manual has been designed to ensure that you get the most from your new product. Please ensure that you are fully conversant with the information provided paying particular attention to the safety precautions. -
Page 4: Safety
Ensure that you take additional safety precautions SAFETY when you are welding in electrically hazardous These general safety norms cover both arc welding conditions such as damp environments, wearing machines and plasma cutting machines unless wet clothing, and metal structures. Try to avoid otherwise noted. - Page 5 Never use broken or faulty welding helmets. Always ensure machine covers and protective devices are in operation. Always ensure there are adequate protective screens or barriers to protect others from flash, Precautions against fire and explosion glare and sparks from the welding area. Ensure Avoid causing fires due to sparks and hot waste or that there are adequate warnings that welding or molten metal...
-
Page 6: Product Overview
those for domestic use where electricity is provided welding operations should be handled with care. via the low voltage public distribution system. Never allow the electrode, electrode holder or any Difficulties arise assuring class other electrically “hot” parts to touch a cylinder. electromagnetic compatibility for systems installed Keep your head and face away from the cylinder in domestic locations due to conducted and... -
Page 7: Panel Layouts
PANEL LAYOUTS Power source Front view Digital ammeter Crater current control Current control for MMA mode. MMA / MIG MAG selector switch Air vent "+" Output terminal: To connect the Interconnection cable Control cable connector. "-" Output terminal: To connect the work clamp. 2T / 4T Selector Gas purge / Weld selector Inductance control... - Page 8 Wire Feed unit Front view Wire speed control Wire inch button Torch connector Water connections Voltage control Wire Feed unit Right side view Shield gas connection Torch holder Control Cable Water connection Water connection Welding cable connection Welding wire spool cover Interconnection cable Left side view Wire feed assembly...
-
Page 9: Unpacking
plug of the work return lead into the “-”ve socket UNPACKING on the front panel of the welding machine, and Check the packaging for any signs of damage. tighten it clockwise. Carefully remove the machine and retain the Select the MMA mode with the selector switch. packaging until the installation is complete. -
Page 10: Maintenance And Troubleshooting
socket of the welding machine and connect professional knowledge on electric aspects and the other connection into the rear of the wire feed comprehensive safety knowledge. Make sure the unit. input cable of the machine is disconnected from Install the wire reel onto the wire hub inside the the electricity supply and wait for 5 minutes before spool cover. -
Page 11: Technical Parameters
to lengthen service life of arc welding machine. Only professional maintenance personnel should repair the machine! Troubleshooting Ensure the power is disconnected before working Before arc welding machines are dispatched from on the machine. Always wait 5 minutes after power the factory, they have already been checked switch off before opening the case. - Page 12 MIG/MAG Series MIG 270 Order code ZXJM-272 MIG 350 Order code ZXJM-352 MIG 450 Order code ZXJM-452 © Wilkinson Star Limited A WILKINSON STAR PRODUCT 10-17 ISSUE 3...