Adding An Apweb Board - AMX Optima AVS-OP-1616-110 Instruction Manual

APWeb Expansion Board

Adding an APWeb Board

If the APWeb board has been pre-installed, go directly to the instructions on page 149 for cabling and
applying power to the enclosure.
If the APWeb board was ordered to upgrade a system, complete the steps below and then see the
instructions on page 149 for cabling and applying power.
ESD Warning: To avoid ESD (Electrostatic Discharge) damage to sensitive components, make sure
you are properly grounded before touching any internal Optima materials. Use an ESD wristband
and cord with alligator clip attached to a good ground source.
Note: The APWeb board can be inserted into either of the expansion slots.
To add an APWeb board to an enclosure:
1.
Unplug the enclosure's power cord (in multi-enclosure systems, turn off all power switches and
unplug all enclosures).
2.
Remove the screws holding the expansion plate.
3.
Remove the expansion plate.
4. Insert the APWeb board into the empty expansion slot, aligning the board between the
upper and lower guides inside the slot, pushing until the board is flush with the rear of the
enclosure (FIG. 118).
FIG. 118
Insert the APWeb board into expansion slot and replace screws
5. Replace the screws.
6.
For cabling instructions, including the power-up sequence, see page 149.
148 Optima Instruction Manual