Attaching Cables - AMX Optima AVS-OP-1616-110 Instruction Manual
Distribution matrix
Hide thumbs
Also See for Optima AVS-OP-1616-110:
- Product view (1 page) ,
- Configuration manual (4 pages)
Table of Contents
Advertisement
Y/c Input/Output Board
Attaching Cables
When attaching video input and output cables, refer to the sheet labeled "AutoPatch Optima Connector
Guide" that shipped with the system. The sheet shows where to attach each cable on the rear of each
enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multi-enclosure systems, each enclosure will be numbered (e.g., "Chassis 1
of 3") on a label located on the left side (near the power receptacle).
The input connectors (white BNCs) are on the left side of each Optima board, and the output connectors
(black BNCs) are on the right side. Input and output connectors are numbered separately. The number of
BNC connectors depends on the I/O configuration. The enclosure may also contain I/O boards for
additional signal types.
To connect Y/c video inputs and outputs:
1.
Fasten the cable pairs onto the input and output BNC connectors (FIG. 78).
Y
Y
C
C
Y
Y
C
C
Y
Y
C
C
FIG. 78
Fasten the cables onto the "Y" and "C" connectors
Make sure the video cable is connected to the correct BNC connector on the correct enclosure. Y/c I/O
boards look similar to standard video and wideband (300 MHz) boards, but the "AutoPatch Optima
Connector Guide" identifies them.
Note: For instructions on installing or replacing a Y/c board, see "Appendix D
I/O Boards" on page 63.
96
Y
Y
Y
Y
Y
Y
Y
Y
Y
C
C
C
C
C
C
C
C
C
Y
Y
Y
Y
Y
Y
Y
Y
Y
C
C
C
C
C
C
C
C
C
Y
Y
Y
Y
Y
Y
Y
Y
Y
C
C
C
C
C
C
C
C
C
Y
Y
Y
Y
Y
C
C
C
C
C
Y
Y
Y
Y
Y
C
C
C
C
C
Y
Y
Y
Y
Y
C
C
C
C
C
–
Adding or Replacing
Optima Instruction Manual
Advertisement
Table of Contents
