AMX Optima AVS-OP-1616-110 Instruction Manual page 90

7.
If applicable – carefully cut the tie straps on the enclosure's wiring harness to free the power
supply's cables. Unplug the enclosure's AC cable from the power supply's AC connector (FIG. 59).
Note that the connector has a locking tab on the left. The other end of the AC cable remains attached
to the enclosure.
FIG. 59
Unplug AC connector
8.
Unplug the power supply's DC cable from the Backplane (FIG. 60). Note that the connector has
double locking tabs. The other end of the DC cable remains attached to the power supply.
FIG. 60
Unplug DC connector
9. If the power supply has a separate fan cable, unplug the power supply's fan cable from the "FAN
PWR" connector on the Backplane (FIG. 61). If the power supply's fan gets power from the DC
wiring harness, unplugging the DC harness in Step 8 disconnected the fan.
FIG. 61
Unplug fan cable
Optima Instruction Manual
Appendix E – Replacing an Optima Power Suppy
Power supply AC connector
AC wiring harness
DC cable
Fan cable
83