AMX Optima AVS-OP-1616-110 Instruction Manual page 94

8.
Blank front panels – Support the panel from below. Plug the power indicator cable into the
"STBY PWR SWITCH" connector on the Backplane, and go to Step 9.
Control panels – Support the panel from below. Attach the control panel's power indicator cable
into the "STBY PWR SWITCH" connector, and attach the power/control cable into the 4-pin
connector on the Backplane.
FIG. 69
Attach panel cables
9. If the power supply has a separate fan cable, attach the power supply's fan cable connector to the
"FAN PWR" connector on the Backplane (FIG. 52). Otherwise, plugging in the DC wiring harness
in Step 7 will connect the fan to a power source.
FIG. 70
Attach fan cable
Caution: Carefully route the cables to keep them from being pinched under the front panel.
10. Push the front panel back into place, being careful to not strain the cables. Replace and tighten one
screw each on the upper and lower edges of the front panel.
FIG. 71
Replace front panel
11. Apply external AC power to the enclosure.
Optima Instruction Manual
Attach power indicator cable
Appendix E – Replacing an Optima Power Suppy
Attach power/control cable
Fan cable
87