AMX Optima AVS-OP-1616-110 Instruction Manual page 85

Appendix E – Replacing an Optima Power Supply
5.
Place the ring terminal of the enclosure's ground wire over the screwhole in the mount. Replace the
single screw at the top of the power supply mount, securing the ground wire to the mount, and the
power supply mount to the enclosure.
FIG. 48
Replace ground wire and screw
6.
Plug the enclosure's AC wire harness into the AC connector on the power supply (FIG. 49). Note
that the connector has a locking tab on the right.
AC connector
FIG. 49
Attach AC wiring harness
7.
Plug the power supply's DC wiring harness into the "PWR SUPPLY #1" connector on the
Backplane (FIG. 50). Note that the connector has double locking tabs.
FIG. 50
Attach DC wiring harness to "PWR SUPPLY #1"
78
"PWR SUPPLY #1" connector
Optima Insturction Manual