Attaching Cables - AMX Optima AVS-OP-1616-110 Instruction Manual

Attaching Cables

When attaching video input and output cables, refer to the sheet labeled "AutoPatch Optima Connector
Guide" that shipped with the system. The sheet shows where to attach each cable on the rear of each
enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multi-enclosure systems, each enclosure will be numbered (e.g., "Chassis 1
of 3") on a label located on the left side (near the power receptacle).
The input connectors are on the left side of each Optima board, and the output connectors are on the right
side. Input and output connectors are numbered separately. The number of HD-15 connectors depends
on the I/O configuration. The enclosure may also contain other I/O boards for additional signal types.
To connect HD-15 inputs and outputs:
1. Fasten the cables onto the input and output HD-15 connectors (FIG. 84).
FIG. 84
Fasten the cable onto the input or output HD-15 connector
HD-15 Pinout
Pinout information for the High Density HD-15 connector on the RGBHV/HD-15 I/O board is provided
below.
FIG. 85
RGBHV/HD-15 board connector pinout
Note: For instructions on installing or replacing an RGBHV/HD-15 board, see "Appendix D
or Replacing I/O Boards" on page 63.
Optima Instruction Manual
RGBHV/HD-15 Input/Output Boards
RGBHV/HD-15 Board Connector Pinouts
Input (VESA DDC Compliant)
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 VDC in DDC
5. GND 10. GND
Output
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 VDC out DDC 14. Vertical sync
5. GND 10. GND
Note: 55 mA supplied on output pin 9;
power draw not to exceed 50 mA per port.
11. ID Bit
12. DDC SDA
13. Horizontal sync
14. Vertical sync
15. DDC SCL
11. ID Bit
12. ID Bit
13. Horizontal sync
15. ID Bit
–
Adding
105