Attaching Cables & Wires (Rx Module) - AMX Optima AVS-OP-1616-110 Instruction Manual

Attaching Cables & Wires (RX Module)
Important: To guarantee 1,000 ft. (305 m) skew compensation, the inter-pair skew must equal
<20 ns/ 100 m. Pre-installed cables should be tested for skew. Cables will work if they test less than
62 ns skew and are within 1,000 ft. (305 m).
CatPro Supported Cables
Note: Skew-free cable is not recommended for use with AMX AutoPatch equipment.
To attach cables and wires to the CatPro RX Module:
1.
Insert the HD-15 connector (FIG. 113) into the Video Out connector.
FIG. 113
CatPro RX Module connectors and audio wiring
2. Wire the audio connector (FIG. 113).
3.
Insert the RJ-45 connector into the UTP/STP In receptacle.
4.
Plug the power cord into the power jack and into the power source.
Note: For adjustment procedures when CatPro RGBHV+Stereo RX Modules are used in
conjunction with Optima CatPro input/output boards, see page 139.
RX HD-15 Video Out Pinout
FIG. 114
Pinout for CatPro RX Module HD-15 connector
Optima Instruction Manual
CAT-5
CAT-5e
CAT-6
CAT-6e
STP (Shielded Twisted-Pair)
Power
RJ-45
RGBHV+Stereo to CatPro Input/Output Boards
Audio
HD-15
RX Module HD-15 Connector Pinout
Output
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 VDC out DDC 14. Vertical sync
5. GND-N/C 10. Ground
Note: 55 mA supplied on output pin 9;
power draw not to exceed 50 mA per port.
Unbalanced audio
11. ID Bit
12. ID Bit
13. Horizontal sync
15. ID Bit
143