AMX Optima AVS-OP-1616-110 Instruction Manual page 81
Distribution matrix
Hide thumbs
Also See for Optima AVS-OP-1616-110:
- Product view (1 page) ,
- Configuration manual (4 pages)
Table of Contents
Advertisement
Appendix E – Replacing an Optima Power Supply
3.
Remove the screws (may total 4 or 6 depending on type of panel) on the upper and lower edges of
the front panel (FIG. 37).
FIG. 37
Remove front panel screws
4.
Lower the top edge of the front panel being careful not to pull or to put stress on the attached cables.
Support the panel from below (FIG. 38).
FIG. 38
Lower & support front panel
5.
Unplug the front panel power indicator cable from the "STBY PWR SWITCH" connector on the
Backplane (the "BACKPLANE" label is above the AutoPatch logo); see FIG. 39.
Backplane
FIG. 39
Unplug power indicator cable
74
Front panel power indicator cable
Optima Insturction Manual
Advertisement
Table of Contents
