AMX Optima AVS-OP-1616-110 Instruction Manual page 86

8.
Blank front panels – Support the panel from below. Plug the power indicator cable into the
"STBY PWR SWITCH" connector on the Backplane (FIG. 51). Go to Step 10.
FIG. 51
Attach power indicator cable to "STBY PWR SWITCH"
Control panels – Support the panel from below. Plug the power indicator cable into the
"STBY PWR SWITCH" connector (FIG. 51).
CP-15 – Plug the interface cable into the 4-pin Serial Interface connector (FIG. 52).
CP-20A – Plug the interface cable into the 3-pin Neuron Interface connector, and the power cable
(3-pin with locking tabs) into the "CP POWER" connector (FIG. 52).
FIG. 52
Attach control panel cable(s)
9.
If the power supply has a separate fan cable, attach the cable connector to the "FAN PWR"
connector on the Backplane (FIG. 52). Otherwise, plugging in the DC wiring harness in Step 7 will
connect the fan to a power source.
Caution: Carefully route the cables to keep them from being pinched under the front panel.
10. Push the front panel back into place, being careful to not strain the cables. Replace and tighten one
screw each on the upper and lower edges of the front panel.
FIG. 53
Push the front panel into place
Optima Instruction Manual
Appendix E – Replacing an Optima Power Suppy
Front panel power indicator cable
Neuron interface
(CP-20A)
Serial interface
(CP-15)
CP POWER
(CP-20A)
FAN PWR
79