Toslink Digital Audio Input/Output Boards Specifications; Attaching Cables - AMX Optima AVS-OP-1616-110 Instruction Manual

®
S/PDIF and TosLink Digital Audio I/O Boards

TosLink Digital Audio Input/Output Boards Specifications

Applies to I/O board FG1046-455 and to optical connectors on the combination board FG1046-461.
Also applies to TosLink digital audio I/O boards contained in pre-configured systems.
Specifications
Resolution
Sample Rate
Output Rise and Fall Time
Jitter
CDR (Reclocking)
Connector
AMX reserves the right to modify its products and their specifications without notice.

Attaching Cables

When attaching digital audio output cables, refer to the sheet labeled "AutoPatch Optima Connector
Guide" found inside the back cover of this binder. The sheet shows you where to connect each cable on
the rear of each enclosure. For multi-enclosure systems, each enclosure will be numbered (e.g., "Chassis
1 of 3") on a label located on the left side (near the power receptacle). Follow the sheet exactly; the
system was programmed at the factory to operate only as indicated on the sheet.
The input connectors are on the left side of each Optima board, and the output connectors are on the right
side. Input and output connectors are numbered separately. The number of I/O connectors depends on
the I/O configuration. The enclosure may also contain other I/O boards for additional signal types.
To attach S/PDIF digital audio input and output cables:
1.
Insert S/PDIF digital audio (coaxial) plugs into the S/PDIF digital audio jacks (FIG. 97).
Y
Y
C C
Y
Y
C
C
FIG. 97
Attaching S/PDIF and TosLink digital audio connectors
To attach TosLink digital audio input and output cables:
1. Remove the protective caps from the TosLink jacks.
2.
Insert TosLink digital audio (optical) plugs into the TosLink digital audio jacks (FIG. 97).
Note: For instructions on installing or replacing S/PDIF or TosLink boards, see Appendix D, "Adding
or Replacing I/O Boards" starting on page 63.
126
16 bit to 24 bit
32 kHz, 44.1 kHz, 48 kHz, 96 kHz
<20 nS
<5 nS
Yes
Optical
Y
Y Y
Y
C
C C
C
Y
Y Y
Y
C
C C
C
S/PDIF (coaxial) connector
TosLink (optical) connector
Optima Instruction Manual