Table of Contents
Advertisement
Section 3 Using PTs
NS Series Programming Manual
Procedure for Prohibiting and Allowing Input to All Screen Functional Objects
by Manipulating Specified Communications Addresses
1. In the CX-Designer, select PT – System Settings, select the Touch Switch Lock Control Flag in
the PT Tab Page in the System Settings Dialog Box, and then set the desired communications ad-
dress.
2. Specify Prohibit Touch when ON or Prohibit Touch when OFF as the prohibit condition.
3. The following table shows the Touch Switch Lock Control Flag during operation.
Prohibit/allow input
Prohibit input
Allow input
N
o
t
e
N
o
t
e
N
o
t
e
♦
Unlike with $SB19 in the system memory, a dialog box for the password to cancel the input prohibit
will not be displayed even if the screen is touched with input prohibited.
♦
The Touch Switch Lock Control Flag has priority if both $SB19 in the system memory and the Touch
Switch Lock Control Flag are used as input prohibit conditions.
♦
Entering the System Menu by pressing two corners of the screen (or by pressing any corner twice for
the NS15) is prohibited when input is prohibited using the Touch Switch Lock Control Flag.
3-10-3 Prohibiting and Allowing Input for Individual Functional Objects
Input to functional objects is controlled by control flags for functional objects on NS-series PTs that
accept input.
Method
1. When creating a screen using CX-Designer, select Control flag - Input - Indirect in the property
settings for each functional object and set the control flag address.
2. Input can be prohibited and allowed by changing the status of the specified control flag address.
Prohibiting input:
Allowing input:
N
o
t
e
N
o
t
e
N
o
t
e
♦
If disable is set using the control flag, no input from the PT to that functional object is possible dur-
ing operation.
♦
Control flags also have a function for displaying or not displaying functional objects.
Prohibit touch when ON
Prohibit touch when OFF
Prohibit touch when ON
Prohibit touch when OFF
Change set address status from ON to OFF (1 → 0).
Change set address status from OFF to ON (0 → 1).
3-10 Prohibiting and Allowing PT Operation
Condition
OFF to ON (0 to 1)
ON to OFF (1 to 0)
ON to OFF (1 to 0)
OFF to ON (0 to 1)
3-30
Communications address
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
