Procedure Before Operation - Omron NS10-TV Series Programming Manual

Section 1 Overview
NS Series Programming Manual

1-5 Procedure before Operation

Perform the following procedure to start the PT.
Host
Host settings
1:1 NT Link
1:N NT Link
High-speed 1:N NT Link
Ethernet (Refer to NS-Series
Setup Manual.)
EtherNet/IP (Refer to NS-Series
Setup Manual.)
Controller Link (Refer to NS-Series
Setup Manual.)
Host Link (Refer to Host
Connection Manual: Host Link.)
Temperature Controllers (Refer to
Host Connection Manual: Temp.
Control, MemLink.)
Memory Links (Refer to Host
Connection Manual: Temp.
Control, MemLink.)
For connection with other devices.
(Refer to Host Connection
Manual: Multivendor Connection.)
Programming
PT connections
System maintenance
Note: The system program is installed only in special circumstances, such as when the system program is re-
placed or repaired. (The system program is included with the NS-CXDC1-V @ CX-Designer.)
Refer to NS Series Setup Manual.
Peripheral connections
Power connections
System program installation
(See note.)
Refer to CX-Designer Online Help
and NS-series Setup Manual.
System menu settings
Refer to NS-series Setup Manual.
Host connections
RS-232C (Refer to NS-Series Setup Manual.)
Ethernet (Refer to NS-Series Setup Manual.)
EtherNet/IP (Refer to NS-Series Setup Manual.)
Controller Link (Refer to NS-Series Setup Manual.)
Settings/com check
Operation
PT
Panel installation
Screen transfer
Refer to NS-series Setup Manual and CX-Designer Online Help.
1-32
1-5 Procedure before Operation
CX-Designer
Installation on the
computer
Screen creation
Refer to CX-Designer Online
Help and Programming
Manual.