Omron NS10-TV Series Programming Manual page 626

Section 5 Troubleshooting and Maintenance
NS Series Programming Manual
Message
Time-out error occurs while
downloading by the following
case:
•
Disconnection of the con-
necting cable.
•
Stopped host
•
Incorrect time-out period.
NS5:
Time-out error occurs while
downloading Host
Allocated host: XXXX
Communication error
detected while downloading
by the following case:
•
Corrupted data by noise
•
Transmit error by the host
MRES=XXX, SRES=XXXX
NS5:
Communication error de-
tected while downloading the
data
Allocated host: XXXX
Addressing error exists in the
screen, alarm, data log, or
macro. Correct address set-
ting by the CX-Designer.
Screen No.: XXXX
Allocation Host: XXXX
Allocation Address: XXXX
MRES: XXXX
SRES: XXXX
NS5:
Addressing error exists in the
screen, alarm, data log or
macro.
Screen No.: XXXX
Allocation Host: XXXX
Allocation Address: XXXX
MRES: XXXX
SRES: XXXX
Communication error
detected while uploading by
the following cases:
Corrupted data by noise
Transmit error by the host
Allocation Host: XXXX
NS5:
Communication error de-
tected while uploading the
data
Allocation Host: XXXX
Cause
The communications
cable is not connected
properly.
The host communica-
tions service has
stopped.
The timeout monitor
time is too short.
Data corrupted by
noise.
Invalid host communi-
cations command.
An illegal address is
set.
Data corrupted by
noise
Invalid host communi-
cations command
5-19
Possible countermeasure
Check the cable connection and conduct a
continuity test. Exchange the cable if there is
a cable error. If necessary, rewire the cable.
Check the cable connection and conduct a
continuity test. Exchange the cable if there is
a cable error. If necessary, rewire the cable.
Press the OK Button to go to the System
Menu. Select Data Check to see whether the
address is valid and the communications
settings are correct. Use CX-Designer to
change settings if necessary.
Check the cable connection and conduct a
continuity test. Replace the cable if there is a
cable error, or rewire the cable if necessary.
5-2 Error Messages