Flash On Time - Datalogic QuickScan 2500 Series Product Reference Manual

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode. The select-
able range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond incre-
ments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Scan the bar code: SELECT FLASH ON TIME SETTING on
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the following table for examples of how to set this
feature.
Table 20 Flash On Time Setting Examples
STEP
1 Desired Setting
Divide by 100
2 (and pad with leading zeroes to
yield two digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH ON TIME SETTING
Scan two characters from
5
Appendix D
6 Scan ENTER/EXIT PROGRAMMING MODE
with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
duration which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION EXAMPLES
1,000ms
500ms
(1 sec.)
05 10
'0' and '5' '1' and '0'
SCANNING FEATURES
.
page 89
, that represent the
Appendix D
5200ms 9,900ms
(5.2 sec.) (9.9 sec.)
52 99
'5' and '2' '9' and '9'
PRODUCT REFERENCE GUIDE
283