Datalogic QuickScan 2500 Series Product Reference Manual page 293

REFERENCES
Label ID: Set Individually Per Symbology — continued
Table 17 Label ID Examples
STEP ACTION
1 Scan the ENTER/EXIT bar code
Determine placement of the
Label ID characters BEFORE
2 or AFTER with regard to
scanned data using Label ID
Control, starting on page 81
Scan the bar code selecting
the symbology type you wish
to designate label ID charac-
3
ters for using Label ID Sym-
bology Selection, starting on
page 82
Custom Label ID example
4
(desired characters):
Find hex equivalents from the
ASCII table (inside back cover),
then scan in these digits/char-
acters using the bar codes in
the section: Keypad, starting
5 on page 327. f you make a
mistake before the last char-
acter, scan the CANCEL bar
code to abort and not save the
entry string. You can then start
again at the beginning.
6 Scan the ENTER/EXIT bar code
Scan the ENTER/EXIT bar code
7
once again
Result:
278
QUICKSCAN™ 2500
EXAMPLES
(Reader enters Programming Mode)
Enable as Prefix Enable as Suffix
GS1 DataBar
Code 39
Omnidirectional
D B * = C 3
44 42 2A 3D 43 33
(Reader exits Label ID entry)
(Reader exits Programming Mode)
DB*[bar code data]
[bar code data]=C3
Enable as Prefix Enable as Suffix
Interleaved 2 of 5 Code 32
+ PH
2B 50 48
+[bar code data] [bar code data]PH