Micro Pdf417 Length Control; Micro Pdf417 Set Length 1 - Datalogic QuickScan 2500 Series Product Reference Manual

MICRO PDF417

Micro PDF417 Length Control

This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length:
be set.
Fixed Length:
$CMILC00
Micro PDF417 Length Control = Fixed Length

Micro PDF417 Set Length 1

Specifies one of the bar code lengths for "
Length 1 is the minimum label length if in Variable Length Mode, or the first fixed length
if in Fixed Length Mode. Length includes the bar code's data characters only. Characters
can be set from 0001 to 0366 characters (pad with zeroes) in increments of 01. Any
value greater than 0366 will be considered to be 0366.
See "
Select Micro PDF417 Length 1 Setting
$CMIL1
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
For variable length decoding, a minimum and maximum length may
For fixed length decoding, two different lengths may be set.
Set Length 1" on page 288

0001 = Length 1 is 1 Character

Micro PDF417 Length Control = Variable Length
Micro PDF417 Length Control" on page 215
for detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
ENTER/EXIT PROGRAMMING MODE
$CMILC01
Appendix D, Keypad represent-
CANCEL
PRODUCT REFERENCE GUIDE
.
215