Intercode Delay - Datalogic QuickScan 2500 Series Product Reference Manual

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The select-
able range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 =
3. Go to
4. Scan the bar code: SELECT INTERCODE DELAY SETTING on
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this fea-
ture.
Table 15 - Intercode Delay Setting Examples
STEP
1 Desired Setting
2 Pad with leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
Scan two characters from
5
Appendix D
6 Scan ENTER/EXIT PROGRAMMING MODE
05, 20 = 20, etc
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
page 70
Programming Mode.
duration which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION
KEYBOARD INTERFACE (NOT AVAILABLE FOR QW2500/QD2520)
EXAMPLES
No Delay 5 seconds 60 seconds
00 05
'0' and '0' '0' and '5'
.
page 70
, that represent the
Appendix D
99 seconds
60 99
'6' and '0' '9' and '9'
PRODUCT REFERENCE GUIDE
271