Datalogic QuickScan 2500 Series Product Reference Manual page 296

3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING on
5. Scan the appropriate three digits from the keypad in
the duration which was determined in the steps above. You will hear a two-beep
indication after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this fea-
ture.
Table 18 Scanning Active Time Setting Examples
ACTION
STEP
1 Desired Setting
2 Pad leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT SCANNING ACTIVE TIME SETTING
Scan three characters from
5
Appendix D
6 Scan ENTER/EXIT PROGRAMMING MODE
EXAMPLES
90 Sec.
1 Second
(1.5 min.)
001 090
'0', '0' and '1' '0', '9' and '0' '1', '8' and '0' '2', '5' and '5'
SCANNING FEATURES
.
page 89
, that represent
Appendix D
180 Sec.
255 Seconds
(3 min.) (4.25 min.)
180 255
PRODUCT REFERENCE GUIDE
281