Setting Up The Quickscan™ Qbt/Qm2500 Reader; Charging The Batteries - Datalogic QuickScan 2500 Series Product Reference Manual

SETUP
SETTING UP THE QUICKSCAN™ QBT/QM2500 READER
Follow the steps below to connect and get your reader up and communicating with its
host.
1. Configure the Base Station starting on
2. Charge the Batteries.
3. Link to the Base Station (see
4. Select the Interface Type (see
5. Configure the Reader starting on

CHARGING THE BATTERIES

The battery can also be charged by connecting the reader directly to a host through the
USB Type-C connector available in the bottom of the handle, as shown below.
Alternatively, simply insert the QuickScan™ into the base station / charger. When the
scanner is fully seated in the base, it will sound a "chirp" to indicate that the base has
detected the scanner connection.
The LEDs on the base will indicate the status of the battery. For information about the
LEDs see
14
QUICKSCAN™ 2500
page 19
page 22
"Technical Specifications"
NOTE: Before using the battery, read "Battery Safety" on page 6. Datalogic
recommends annual replacement of rechargeable battery packs to ensure
maximum performance.
.
page 19
).
).
(optional, depends on settings needed)
page 27
on page 292.