Scanning Features; Scan Mode; Scanning Active Time - Datalogic QuickScan 2500 Series Product Reference Manual

REFERENCES

SCANNING FEATURES

Scan Mode

Selects the scan operating mode for the reader. Selections are:
Trigger Single:
ing occurs:
•
•
•
This mode is associated with typical handheld reader operation: when the trigger is
pulled, scanning starts and the product scans until the trigger is released, or a label is
read, or the maximum Stand Mode/Object Detection has elapsed.
Trigger Hold Multiple:
scans until the trigger is released or Stand Mode/Object Detection has elapsed. Reading
a label does not disable scanning.
reads of the same label while in this mode.
Trigger Pulse Multiple:
until Stand Mode/Object Detection has elapsed or the trigger has been released and
pulled again.
while in this mode.
Flashing:
controlled by
tinuously. When Flash is OFF scanning is deactivated.
Always On:
Double Read Timeout
mode.
Stand Mode/Object Detection:
turns on automatically when an item is placed in reader's field of view. While in a stand
watch state, the reader illumination LED goes from dim to maximum bright.
Trigger Object Sense:
matically turns on the illuminator. Decoding is not automatic. To decode it is necessary
to pull the trigger.

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state once the
state is entered. The range for this setting is from 1 to 255 seconds in 1-second incre-
ments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 =
1. Controlled by
280
QUICKSCAN™ 2500
When the trigger is pulled, scanning is activated until one of the follow-
Stand Mode/Object Detection has elapsed
a label has been read
the trigger is released
When the trigger is pulled, scanning starts and the product
When the trigger is pulled, continuous scanning is activated
Double Read Timeout
The reader flashes
and
Flash On Time
No trigger pull is required to read a bar code. Scanning is continually on.
prevents undesired multiple reads of the same label while in this
The reader detects changes within its field-of-view and auto-
005, 20 = 020, etc.
Flash On Time
Double Read Timeout
prevents undesired multiple reads of the same label
1
on and off regardless of the trigger status. Flash rate is
. When Flash is ON the reader reads con-
Flash Off Time
No trigger pull is required to read a bar code. Scanning
.
prevents undesired multiple