Cruise Control Mode - HONDA marine BF350A Owner's Manual

8. OPERATION

CRUISE CONTROL MODE

CRUISE/UP
SWITCH
TROLL/DN
SWITCH
TROLL/DN Switch:
Reduce engine speed or
velocity
CRUISE/UP Switch:
Increase engine speed or
velocity
If you press the CRUISE/UP switch
during cruising with all the remote
control levers in the FORWARD
position, the mode changes to the
cruise control mode, which lets
the boat cruise at a constant
engine speed or velocity.
86
A long buzz sounds once.
• Speed can only be adjusted in
cruise control mode when
equipped with GPS.
You can adjust the engine speed
or velocity by every time you press
the switch once. You will hear a
short buzz.
Continuing to press the switch will
not decrease or increase the
engine speed beyond the lower or
higher limit.
If you try to do this, a short buzz
sounds twice.
Engine speed adjusting range:
Engine speed at mode change
-1
±500 min (rpm) (in steps of 50
-1
min (rpm))
Velocity adjusting range:
– Velocity at mode change ±10
km/h (in steps of 1.0 km/h)
– Velocity at mode change ±5
miles/h (in steps of 0.5 miles/h)
– Velocity at mode change ±5
knots (in steps of 0.5 knots)
The cruise control mode is
released forcibly in the following
cases.
• GPS error or disconnection
(Velocity adjustment is selected
in the multifunction display)
• Operate the remote control
lever a certain amount from the
position for changing modes
• Engine stops or engine is
abnormal (overheating, low oil
pressure, etc.)
• If the engine RPM or speed is
unstable