Power Harness
FUSE HOLDER COVER
POWER HARNESS
SPARE FUSE (40 A)
FUSE PULLER
1. Stop the engine.
2. Disconnect the battery cable
and the power harness.
3. Open the fuse holder cover.
4. Pull the old fuse out of the clip
with the fuse puller supplied in
the fuse box (see page 132).
5. Push a new fuse (40 A) into the
clip.
6. Close the fuse cover.
Main Fuse
Replacement
A spare fuse is located on the
reverse side of the junction box
lid.
1. Stop the engine.
2. Remove the engine cover.
3. Remove the front striker guide
cover (see page 124).
4. Open the junction box lid and
pull the old fuse out of the clip
with the fuse puller supplied in
the fuse holder (see page 132).
5. Push a new fuse into the clips.
6. Close the junction box lid, and
install the front striker guide
cover and engine cover.
12. MAINTENANCE
7. Reconnect the battery.
DESIGNATED FUSE:
7.5 A, 15 A, 30 A
SPARE FUSES (7.5 A, 15 A, 30 A)
JUNCTION BOX LID
131