Tilting The Outboard Motor - HONDA marine BF350A Owner's Manual

The trim support mode is forcibly
canceled in the following cases.
• Trim angle is adjusted beyond
the trim area by the power trim/
tilt switch
• GPS error or disconnection
• Engine malfunction
(overheating, low oil pressure,
etc.)
• Trim operation abnormality
• Accelerating or decelerating so
quickly as to put a load on trim
TILTING THE OUTBOARD
MOTOR
Tilt the outboard motor to prevent
the propeller and gear case from
hitting the bottom when the boat
is beached or stopped in shallow
water.
When dual type outboard motors
are mounted on your boat, tilt
them up at the same time.
1. Move the shift lever or the
control lever to the NEUTRAL
position and stop the engine.
2. Press UP of the power trim/tilt
switch and tilt the outboard
motor to the best position
according to cruising
conditions.
8. OPERATION
Pressing UP of the power trim/tilt
switch of the remote control lever
or PTT switch panel twice in
succession tilts the outboard
motor up to the set tilt angle
automatically.
D1 type
POWER TRIM/TILT SWITCH
91