Station Select Mode; Stopping The Engine; Emergency Engine Stopping - HONDA marine BF115J Owner's Manual

OPERATION
During the warm-up period, check
the oil pressure indicator (p. 55),
overheat indicator (p. 56), and
cooling system indicator (p. 57).
If using a control panel without
indicators type, check the oil
pressure indicator and overheat
indicator displayed on an
NMEA2000-compatible device.
If the indicators show any
abnormal condition, immediately
stop the engine and determine the
cause of the problem. Refer to
TAKING CARE OF
UNEXPECTED PROBLEMS on
p. 133 – 136.
6. If the fast idle control was used to
warm-up the engine, gradually
return the control lever to the N
(neutral) position as the engine
warms up.
74

Station Select Mode

ACT INDICATOR
[-] SWITCH
PRESS and HOLD
For multiple station type, use the [-]
switch to change the operating
station.
If you press and hold the [-] switch of
the inactive station when all remote
control lever is in the NEUTRAL
position, you can operate the
outboard motors using this station.
A long buzz sounds once and the
ACT indicator comes on when the
station can be operated.

STOPPING THE ENGINE

• After stopping the engine, be sure
to turn OFF the ignition switch or
power switch before turning OFF
the battery switch. If the battery
switch is turned OFF while the
ignition switch or power switch is
ON, the buzzer will sound three
times briefly.

Emergency Engine Stopping

Flush-Mount/Top-Mount Types
(DBW type)
EMERGENCY
EMERGENCY
STOP SWITCH
STOP SWITCH
CLIP LANYARD