Table of Contents
Advertisement
12. MAINTENANCE
Replacement
HOSE CLIPS
FUEL HOSES
1. Remove the engine cover (see page 58).
2. Remove the front striker guide cover (see page
124).
3. Remove the relay.
4. Disconnect the 2-pin coupler (blue).
5. Remove the suspension strap from the fuel filter
with water separator bracket, then remove the
suspension strap from the fuel filter with water
separator.
6. Bind the two fuel tubes with the tube clips to
prevent fuel leakage, disconnect the fuel tubes.
126
WATER SEPARATOR
SUSPENSION STRAP
2-PIN COUPLER
(BLUE)
RELAY
FUEL FILTER
WATER SEPARATOR
CUP
7. Remove the three screws holding the fuel filter
with water separator, remove the water or deposit
from the inside of the cup.
8. Thoroughly clean the cup. If the fuel filter is
clogged, or has reached the end of its replacement
period, replace it with a new one.
9. Reassemble the water separator in the reverse
order of removal. Use a new O-ring.
TIGHTENING TORQUE:
3.4 N·m (0.34 kgf·m, 2.5 lbs·ft)
O-RING (Replace)
SCREWS
Advertisement
Table of Contents
