Active Mode (D2 Type) - HONDA marine BF350A Owner's Manual

7. STARTING THE ENGINE
7. Warm up the engine as follows:
Above 5°C (41°F) – run the
engine for 2 or 3 minutes.
Below 5°C (41°F) – run the
engine for at least 5 minutes at
-1
2,000 min (rpm).
Failure to completely warm up
the engine will result in poor
engine performance.
NOTICE
• If the engine is not properly
warmed-up before raising the
engine speed, the warning
buzzer and overheat indicator
may activate and the engine
speed will be automatically
reduced.
NOTE:
Before leaving the dock, check the
operation of the emergency stop
switch.
76

ACTIVE MODE (D2 type)

SINGLE TYPE
ACTIVE SWITCH
DUAL TYPE
ACTIVE/FAST IDLE SWITCH
For multiple station type, use the
ACTIVE switch or ACTIVE/FAST
IDLE switch to change the
operating station (see page 31).
If you press the ACTIVE switch or
ACTIVE/FAST IDLE switch of the
inactive station when all remote
control levers are in the NEUTRAL
position, you can operate the
outboard motors using this
station.
• To release the station selection,
press the ACTIVE switch or
ACTIVE/FAST IDLE switch of the
remote control of the inactive
station, with all the remote
control levers put in the
NEUTRAL position.