Active Switch, Active/Fast Idle Switch; Fast Idle Switch, Active/Fast Idle Switch - HONDA marine BF350A Owner's Manual

ACTIVE Switch, ACTIVE/FAST
IDLE Switch
For multiple station type, use the
ACTIVE switch or ACTIVE/FAST
IDLE switch to change the
operating remote control (active
mode).
If you press the ACTIVE switch or
ACTIVE/FAST IDLE switch on the
remote control you want to
operate the outboard motors
when all remote control levers are
in the NEUTRAL position, the
mode changes to active mode.
FAST IDLE Switch, ACTIVE/
FAST IDLE Switch
If you press the FAST IDLE switch
or ACTIVE/FAST IDLE switch on the
remote control in active mode
when the remote control lever is
in the NEUTRAL position, the
mode changes to the fast idle
mode.
You can adjust the engine speed
by lowering the remote control
lever to the FORWARD or
REVERSE side. In the case of dual
top-mount remote control, the
mode changes to the fast idle
mode only for an engine whose
remote control lever is in the
NEUTRAL position.
4. CONTROLS AND FEATURES
The BF350A model uses
programmed fuel injection, so this
mode will not be needed for
starting. After the engine starts
and if the outside temperature is
below 5°C (41°F), the fast idle
mode can be used to accelerate
engine warm-up.
• You cannot turn on the fast idle
mode without putting the
remote control lever in the
NEUTRAL position.
• If remote controls are mounted
at two places, changing of fast
idle mode can be done only
with the remote control that is
in active mode (see page 31).
• To release the fast idle mode,
press the FAST IDLE switch or
ACTIVE/FAST IDLE switch with
all the remote control levers put
in the NEUTRAL position.
• When fast idle mode is
released, a short buzz sounds
twice.
31