Trim Support Mode - HONDA marine BF350A Owner's Manual

8. OPERATION

Trim Support Mode

POWER TRIM/TILT SWITCH
Press UP to
raise bow.
Press DN to
lower bow.
TRIM SPT. SWITCH
REMOTE CONTROL LEVER
Pressing the TRIM SPT. switch
changes the mode to the trim
support mode, which
automatically does trim
operations according to the speed
or engine RPM.
90
Adjusting the trim angle to an
optimum position automatically
during acceleration or cruising
improves acceleration
performance, top speed, steering
stability, fuel efficiency, etc.
The conditions that control the
trim angle pattern is set in the
multi-function display.
The trim support switch (TRIM
SPT. switch) can be used
regardless of whether the boat is
stopped or cruising.
You can finely adjust the trim
angle manually while in trim
support mode.
In the case of a single outboard
motor, if you press the power
trim/tilt switch of the remote
control while in trim support
mode, you can fine-tune the trim
angle.
In the case of multiple outboard
motors, if you press the power
trim/tilt switch of the remote
control in the trim support mode,
you can fine-tune the trim angles
of all the outboard motors
simultaneously.
The finely adjusted angle is
temporarily overwritten with the
preset pattern, and returns to the
pattern before overwriting when
the engine switch or power switch
is turned off.
If you use the cruise control mode
while in the trim support mode,
the trim support mode is
temporarily stopped.