Automatic Tilt Mode - HONDA marine BF350A Owner's Manual

8. OPERATION
TRIM ROD
3. Press DN (down) of the power
trim/tilt switch and fully shorten
the trim rods.
4. To tilt down, raise the outboard
motor as far as it goes using the
power trim/tilt switch, move the
tilt lock levers to the FREE
position, and lower the
outboard motor to the
designated position.
94
NOTICE
• Do not start the engine while
the tilt lock lever is locked.
There is a risk of damaging
the engine.
Pressing DN of the power trim/tilt
switch of the remote control lever
or PTT switch panel twice in
succession tilts the outboard
motor down to the set tilt angle
automatically (see page 36).

Automatic Tilt Mode

If you press the power trim/tilt
switch twice in succession while
the boat is stopped, the automatic
tilt mode is turned on,
automatically tilting up or down
the outboard motor.
When the "UP" side of the power
trim/tilt switch is pressed twice in
succession, the buzzer sounds
once at a long interval, and the tilt
is automatically raised to the
preset tilt limit position. The
buzzer continues to sound at
short intervals while the outboard
motor is tilted up.