Table of Contents
Advertisement
Changing the lens
Inserting a new lens
1.
Remove the front and rear lens cap from the lens.
2. Insert the lens with the connector in the upright position.
Installation & Quick Start Guide
CHANGING THE LENS
Digital Projection Ltd. M-Vision WUXGA Series
Notes
Before changing the lens,
always make sure the
projector is switched off and
fully disconnected from its
power supply.
When changing the lens,
avoid using excessive force
as this may damage the
equipment..
Avoid touching the surface
of the lens as this may result
in image impairment.
The lens is shipped
separately..
Take care to preserve the
original lens packaging and
protective caps for future
use.
The projector will not power
on without the lens fitted..
Rev A January 2024
page 29
Advertisement
Table of Contents
