Table of Contents
Advertisement
Power on / off
•
Auto Power Off
Set this to On if you want the projector to go into STANDBY mode when no input
source is detected for 20 minutes.
•
Auto Power On
Set this to On if you want the projector to start up immediately when the mains is
connected. Set this to Off if you want the projector to go into STANDBY mode when
the mains is connected. In this case, the projector will not start up until the POWER
button is pressed on the control panel or the ON button is pressed on the remote
control.
•
Scheduled on-off
Access this submenu to create a weekly schedule for automatic on and off times:
1.
Set a schedule:
•
Use the UP and DOWN arrow buttons to highlight a row, then press
ENTER/OK to enable edit mode.
•
Within a row, navigate with the LEFT and RIGHT arrow buttons. Set values
with the UP and DOWN arrow buttons.
•
To exit edit mode, press ENTER/OK. Alternatively, press EXIT if you don't
want the changes to take effect. Move to another row using the
UP and DOWN arrow buttons.
2. To enable the schedule, set Schedule to On.
•
Instant Startup
When ON only the Laser will be turned off when the Power off command is given.
A subsequent Power On will turn on the laser giving an apparent very fast power on.
•
Standby Period
Used with Instant Startup. If Instant Startup in ON and the projector is powered
down then the projector will go to Standby after the selected "Standby Period"
30 minutes, 60 minutes, 90 minutes.
Operating Guide
USING THE PROJECTOR
Power on/off Management
Auto Power Off
Auto Power On
Scheduled on-off
Instant Startup
Standby Period
Scroll
Scheduled on-off
Schedule
Sun
Mon
Tue
On
Off
On
Off
Scroll
Digital Projection Ltd. M-Vision WUXGA Series
Off
Off
Off
30 Min.
Enter
Back
Off
Wed
Thr
Fri
Sat
Time
12 : 34
12 : 34
12 : 34
12 : 34
Enter
Back
Notes
Rev A January 2024
page 81
Advertisement
Table of Contents
