Table of Contents
Advertisement
17. DISPLAYPORT 1 / R / numeric input 4
Select DisplayPort 1 input.
18. HD-T / G / numeric input 5
Select the HDBaseT input.
19. VGA / 3D / numeric input 7
There is no VGA input on this projector.
Use with ALT to toggle the 3D Format setting between Off and Auto.
20. COMP1 / EYE / numeric input 8
There is no Component 1 input on this projector.
Use with ALT to switch between left and right eye 3D dominance.
21. ADDR / ALL (with red indicator at the top)
Assign and unassign an IR remote address.
•
To assign an IR remote address:
1.
Press and hold this button until the red indicator starts flashing.
2. Release this button and while the red indicator is still flashing, enter a two-
digit address using the numeric input buttons. The indicator will flash three
times quickly to confirm the change.
•
To unassign an address and return to the
default address 00:
1.
Press and hold ALT and this button simultaneously until the red indicator
flashes to confirm the change.
22. SDI / B / numeric input 6
Select the 12G-SDI input.
23. TEST / SWAP / numeric input 0
Show a test pattern. Press again to show the next test pattern: Off, White, Black, Red,
Green, Blue, Checkerboard, Crosshatch, Color Bar, Aspect Ratio.
24. COMP2 / PIP / numeric input 9
There is no Component 2 input on this projector.
Installation & Quick Start Guide
REMOTE CONTROL
17
18
19
20
Remote Control
Digital Projection Ltd. M-Vision WUXGA Series
Notes
This projector does not use
21
the following options on the
remote: DVI, VGA, HDMI 3,
22
HDMI 4, COMP 1, COMP 2,
23
PIP and SWAP.
24
Rev A January 2024
page 23
Advertisement
Table of Contents
