Table of Contents
Advertisement
Digital Projection Ltd. M-Vision WUXGA Series
Some 3D settings explained
Eye swap
The outgoing 3D frames are in pairs - the
dominant frame being presented first.
You can determine which frame should
be the dominant one.
By convention the default setting is Left.
Dark time
Banding can be caused if the image is
displayed before each eye of the 3D
switching glasses or ZScreen is not fully
open.
Dark Time allows you to minimize this effect. .
Rev A January 2024
page 74
USING THE PROJECTOR
LEFT 1
RIGHT 1
LEFT 2
Dominance Left
RIGHT 1
LEFT 1
RIGHT 2
Dominance Right
Fully On
Left
Fully Off
Dark
Time
RIGHT 2
LEFT 3
RIGHT 3
LEFT 2
RIGHT 3
LEFT 3
Right
Dark
Dark
Time
Time
Notes
In order to achieve maximum
light output and a smooth
grayscale, whilst eliminating
ghosting, the following
procedure is recommended:
1.
Set Dark Time to a
value appropriate to the
glasses or ZScreen, say
1.3 ms or 1.95 ms.
2. Adjust Sync Offset time
to eliminate ghosting
and achieve a smooth
grayscale.
3. Repeat steps 1 and 2
until the best result is
obtained.
Operating Guide
Advertisement
Table of Contents
